How to Tell When Your Pool Filter Needs Cleaning

How to Tell When Your Pool Filter Needs Cleaning

A dirty filter means cloudy water and a pump that’s working harder than it should. With the dust and wind we get in West Texas, filters in Lubbock have plenty to catch.

Here’s how to tell when yours needs attention, and what a professional filter cleaning involves.

Signs Your Filter Needs Cleaning

  • Your pressure gauge reads 8 to 10 PSI higher than its clean starting pressure.
  • Weak water flow is coming back into the pool through the wall jets.
  • The water is cloudy or hazy and doesn’t clear up even after you add chlorine.
  • Dirt or DE powder blows back into the pool when the pump turns on.

That last one usually points to more than a dirty filter. When dirt comes back into the pool, something inside the filter is often torn or broken, like a DE grid, the manifold, or a standpipe. That lets dirt slip right past the filter.

High Pressure vs. Low Pressure

High pressure generally means a dirty filter. Low pressure points to a different problem on the suction side of the system. We diagnose pressure issues and replace broken gauges, so you can trust what yours tells you.

How We Clean Each Type of Filter

Cartridge filters. We take the cartridges out, soak them if needed to break down oils, and pressure wash deep into the pleats to restore flow.

DE filters. We fully take the filter apart, wash the grids, and inspect the manifold for cracks. Then we put it back together and recharge it with fresh DE powder.

Sand filters. When backwashing stops working, the sand has usually worn smooth and rounded. We do a full sand change with fresh media.

If you’re on our weekly pool cleaning service and have a sand or DE filter, we backwash it when the pressure gauge shows it’s needed.

What a Filter Cleaning Visit Looks Like

  1. Shut down and relieve pressure. We turn off the pool equipment at the breaker and open the air relief valve to depressurize the tank before we open it.
  2. Take it apart and inspect. We remove the clamp band and lid, pull out the cartridges or grid assembly, and check the manifold, grids, and tank o-ring for damage.
  3. Deep clean. We wash between the cartridge pleats, or strip old powder and debris off the DE grids, until they’re clean.
  4. Reassemble and restart. We lubricate the tank o-ring, put the filter back together, restart the system, check for leaks, and add fresh DE powder if you have a DE filter.

Other Filter Problems We Fix

  • Leaking tanks. A worn tank o-ring lets water out and air in. We replace it and lubricate the seals.
  • Stiff or leaking valves. A bad push-pull or multiport valve keeps you from backwashing properly. We rebuild or replace it.

Repair or Replace?

We look for a sensible repair first. A torn DE grid, a cracked manifold, or a leaking o-ring can usually be fixed by replacing just that part.

Replacement makes more sense when:

  • The fiberglass tank is splintering on the outside (called fiberglass bloom)
  • The tank has a structural crack
  • Replacing all the internal parts would cost close to what a new filter costs

If it’s time for a new filter, we help you choose the right size and type for your pool. Either way, you get a free written quote after we’ve seen it.

Schedule a Filter Cleaning

Desert West Pools cleans and repairs cartridge, DE, and sand filters throughout Lubbock. Call (806)602-0280 or request your free estimate online.

Tags

pool filter cleaning lubbock

Share this Post