Pool Heater Clicking But Not Lighting? Common Heater Problems and What They Mean
A broken heater can cut your swimming season short. Pool heaters combine water, electricity, and often gas, so it pays to know what the warning signs mean and when to call for help.
Desert West Pools repairs both gas pool heaters and electric heat pumps. Here are the problems we see most often.
Clicking, But It Won’t Light
If you hear the ignitor clicking but the burner never lights, something is failing in the ignition sequence, or there’s a gas supply issue. The same goes for a heater that lights and then shuts right off. We test the ignitor, the flame sensor, and the gas valve to find the cause.
Error Codes on the Display
Modern heaters show error codes like “LO,” “IF,” “HLS,” or “Service Heater” when their safety sensors detect a fault and shut the unit down. Each code points to a specific problem. We read the code and make the repair it calls for.
The Heater Won’t Fire at All
A heater won’t fire if it doesn’t sense enough water flow. That can come down to a bypass valve, a bad pressure switch, or a dirty filter. Sometimes a heater “problem” is really a filter that needs cleaning.
It Shuts Down Too Early
Heaters use thermal regulators and high-limit switches to keep from overheating. When one of those sensors goes bad, the heater can shut down before it should. We replace faulty sensors.
Blank Screen or Unresponsive Keypad
This usually points to a failed control board or display membrane. Both can be replaced.
Soot or Dark Exhaust
Black soot around the exhaust vent means the gas isn’t burning completely. It’s often caused by a blocked heat exchanger or the wrong gas pressure. This is a fire hazard. Call for service right away.
Water Puddling Under the Heater
A leak inside the heater cabinet usually means the copper heat exchanger has corroded through. The most common cause is poor water chemistry, which is one more reason balanced water matters. Our weekly pool cleaning service tests and balances your chemistry on every visit.
Repair or Replace?
We’ll give you an honest assessment.
Repair is usually the right call when the heater is fairly young and the problem is a failed sensor, a bad control board, or a dirty ignitor.
Replacement is usually the better choice when the heater is leaking from inside. That means the heat exchanger has failed, and replacing one often costs nearly as much as a new heater. It also leaves all the other aging parts in place. In cases of severe internal corrosion, we’ll recommend a replacement for your safety and long-term reliability.
Either way, you get a free written quote before any work begins.
How a Heater Repair Visit Works
- We start with the basics: water flow, gas pressure, and electrical supply. Then we test parts like the pressure switch, thermal regulator, and ignitor to find the exact cause.
- We give you a written quote for the repair. We also inspect the heat exchanger. If it’s badly rusted and unsafe, we’ll talk through replacement instead of a temporary fix.
- Repair and test. After you approve the work, we install the parts, fire up the heater, confirm it ignites properly, check for gas and water leaks, and make sure it reaches temperature before we leave.
We service major heater brands, including Pentair, Hayward, Jandy, and Raypak, and we use OEM replacement parts.
Gas Heater or Heat Pump Installation
If it’s time for a new heater, we install both types:
- Gas heaters (natural gas or propane) heat quickly and are popular with homeowners who have an attached spa. We make sure the gas line is sized correctly, the venting is safe, and the unit is properly bonded.
- Electric heat pumps pull heat from the air and transfer it to the water. They’re an energy-efficient way to keep a steady pool temperature. They need a dedicated high-amp breaker, so we check that your electrical panel can handle the load.
Get Your Heater Back Up and Running
Call Desert West Pools at (806)602-0280 or request a free estimate online for pool heater repair in Lubbock and the surrounding area.