Pool Pump Making Noise? What Screeching, Humming, and Leaks Usually Mean

Pool Pump Making Noise? What Screeching, Humming, and Leaks Usually Mean

Your pump keeps the water in your pool moving. When it stops, algae starts. Most pumps give you some warning before they quit, so it helps to know what those warnings sound and look like.

Here are the most common pump problems we see in Lubbock, and what usually causes them.

Loud Screeching or Grinding

A high-pitched squeal is the classic sign of failing motor bearings. In most cases, a shaft seal failed and let water into the motor casing, and the bearings rusted out.

The fix is usually a new motor, ideally before the old one seizes up completely. The good news is that if the wet end (the plastic housing that holds the basket) is still in good shape, we can often replace just the motor and seals. You keep your existing housing and avoid replumbing the equipment pad.

Humming, But Not Pumping

If your pump hums when the timer clicks on but never gets going, a bad start capacitor is a common cause. It’s usually an easy repair. Don’t let it keep humming, though. Leaving it that way can burn out the motor.

Humming pumps, tripped breakers, and pumps that won’t run at all often come down to electrical problems: a bad capacitor, damaged wiring, or a failed timer. We test the electrical components with a multimeter to find the fault safely.

Water Puddling Under the Pump

A puddle under your pump usually means the mechanical shaft seal has failed. If it isn’t fixed, that water eventually reaches the motor bearings and rusts them. That’s how a simple seal replacement turns into a motor replacement.

Pump Keeps Losing Prime

If your pump basket is full of air and the pump struggles to pull water, there’s likely a suction leak. Common spots are the lid o-ring, the plumbing joints, and the valves. A suction leak forces the pump to work too hard, so it’s worth tracking down.

Low Flow or Surging

When flow drops off or the pump surges, the impeller may be clogged. We take apart the wet end and clear out whatever is blocking the water, whether it’s pine needles, rocks, or other debris.

Repair or Replace?

We look at the age and condition of the whole unit before we recommend anything.

Repair usually makes sense when the pump is relatively new and the problem is a bad capacitor, a leaky seal, or a jammed impeller.

Replacement usually makes sense when you have an older single-speed pump, the plastic housing has gone brittle from the sun, and the motor has died. In that case, we recommend upgrading to a variable-speed pump. They filter well and use far less electricity than older single-speed pumps, which brings down your monthly pool energy costs.

Either way, you get a free written quote that lays out the parts, labor, and your options before any work starts.

Variable-Speed and Booster Pumps

Variable-speed pumps have onboard drives, so diagnosing them takes some specialized knowledge. We troubleshoot error codes and connection problems and figure out whether the issue is the drive, the communication wiring, or the motor.

If you use a pressure-side cleaner like a Polaris, you also have a booster pump. When it fails or starts leaking, the cleaner stops moving and debris piles up fast. We repair booster pumps too.

Brands We Work On

We service all major pump brands, including Pentair, Hayward, and Jandy.

After the Repair

Once the work is done, we prime the pump, check the pressure, and make sure there are no leaks and the water is circulating strongly before we call the job complete.

Get Your Pump Looked At

If your pump is screeching, humming, leaking, or losing prime, call Desert West Pools at (806)602-0280 or request a free estimate online. We provide pool pump repair throughout Lubbock and nearby towns.

Tags

pool pump repair lubbock

Share this Post